Enterprise Routing and Switching, Professional (JNCIP-ENT) (JN0-649) is a professional-level Juniper certification exam. The blueprint splits the exam across 6 domains, starting with Advanced OSPF and BGP, EVPN-VXLAN, Advanced Switching. On exam day you face around 65 questions in 90 minutes, in formats such as multiple choice. The 10 questions below are free samples written to match that style: answer each one first, then reveal the correct answer and note which topics you miss. The JN0-649 is rated hard in difficulty, and most candidates prepare with at least 24 months of hands-on experience. Because every answer is revealed in place, you can work through the whole set without leaving this page. Work through all 10 samples before deciding whether to buy the full 35+ question PDF.
Looking for more? Click here to get the full PDF with 35+ practice questions for $5 for offline study and deeper preparation.
You are using 802.1X authentication in your network to secure all ports. You have a printer that does not support 802.1X and you must ensure that traffic is allowed to and from this printer without authentication. In this scenario, what will satisfy the requirement?
You are asked to enforce user authentication using a captive portal before users access the corporate network. Which statement is correct in this scenario?
Your network is multihomed to two ISPs. The BGP sessions are established; however, the ISP peers are not receiving any routes. Which two statements are correct about troubleshooting your configuration? (Choose two.)
You are deploying IP phones in your enterprise network that must receive their power through their Ethernet connection. You are using your EX Series switch's PoE ports that support IEEE 802.3af. In this scenario, what is the maximum amount of power allocated to each interface?
There are two BGP routes to 10.200.200.0/24 received from two external peers. Route 1 comes from a neighbor with a router ID of 10.10.100.1 and a peer IP address of 10.10.30.1, and route 2 comes from a neighbor with a router ID of 10.10.200.1 and a peer IP address of 10.10.50.1. Both routes have the same MED value, origin value, AS path length, and local preference number. In this scenario, which statement is correct about the active route?
Which statement is correct about IS-IS?
You must ensure that all routes in the 10.0.0/8 address range are not advertised outside of your AS. Which well-known BGP community should be assigned to these addresses to accomplish this task?
A Layer 2 connection does not expend across data centers. The IP subnet in a Layer 2 domain is confined within a single data center. Which EVPN route type is used to communicate prefixes between the data centers?
You are asked to configure 802.1X on your access ports to allow only a single device to authenticate. In this scenario, which configuration would you use?
Which three configuration parameters must match on all switches within the same MSTP region? (Choose three.)
No. They are original practice questions written to match the format and topic mix of the Enterprise Routing and Switching, Professional (JNCIP-ENT) exam, which contains around 65 questions. Treat them as representative practice, not leaked exam content.
This page includes 10 questions, each with its correct answer you can reveal in place. The full study PDF expands that to 35+ questions.
Yes. Open the answer panel under each question to see which option is correct. Answer first, then reveal, so the set works as a self-check rather than a reading exercise.
Not on its own. Use the samples to find weak topics, revise them against the official domains, then work through the full 35+ question set under timed conditions before booking the exam.
Download the complete JN0-649 study bundle with 35+ questions in a single printable PDF.
Start typing to search exams
Access practice tests for AWS, Microsoft, Cisco and more.